Prevent Water Damage in the Laundry Room

Posted on: 27 October, 2009 - Category: Room, Tips & Guide by:

The washer and drier are usually located in the laundry room and create heat and moisture. Simple maintenance is required to help avoiding water problems and mold.

The Washer
The washer is connected to both cold and hot water lines. Check them frequently. Start with the joints and fix a leak if you find it. Be sure to check both ends of the water lines. Clean or replace the filters once in a while. A blocked filter will slow the water flow into the washing machine, and may cause some malfunctions. This problem is worse in areas with “hard water”. Inspect the shut off valve by looking for drips into the washing machine while it is not in use. If you detect a leak, replace the valve.

Hoses & Filters

Like in most appliances, problems often start in the hose. Keep at least 4 inches between the water connection and the back of the washer. This space will prevent the hose from kinking and bursting. Check the hoses and replace them if old. Consider installing steel-braided hoses.

The Dryer
The dryer is connected to a ventilation hose. Check it carefully. The dryer ventilation hose must be connected to the outdoors. Search for lint behind and under the dryer and make sure the vent pipe is not clogged. Make the exhaust short as possible for the dryer to vent efficiently,

Utility Sink
The utility sink is sometimes the source for water related problems. Search for leaks under the sink. A drip in the trap under the sink can be a sign for problems and should be repaired immediately. Slow draining pipes may indicate a partially blocked drain. A constantly dripping faucet must me repaired promptly. Replace sink seals if they are cracked or loose. Damped or stained walls around plumbing pipes indicate an internal leak that must be fixed before additional damage occurs

Add Comments

Leafy Pumpkins

Posted on: 18 October, 2009 - Category: General by:

Step 1: Using a large leaf (or a leaf pattern enlarged to fit your pumpkin), transfer design onto the center of an intact pumpkin.
Step 2: With a pencil draw a complementary shape to frame the leaf design, preferably leaving at least 1/2 inch of space on all sides of leaf edges.
Step 3: Use a scraping tool to peel away flesh between leaf shape and its frame. With the same tool, carve leaf veins in a freehand pattern.
Step 4: Arrange multiple silhouetted pumpkins along the center of an outdoor table. Add stones or leaves to complete the setting.

1 Comment

Hiding the Litter Box In a Closet

Posted on: 11 October, 2009 - Category: House / Home Design, Tips & Guide by:

Cats are great apartment/condo pets. They require little space, they don’t have to be walked, and they’re not as prone to “accidents” as dogs. However, finding a location for a litterbox in a small space can be frustrating.

This lucky kitty practically has her own bathroom! Through the pet door installed in this door, the cat is able to access her litterbox on the closet floor. This not only keeps the box out of sight, it also leaves a little floor space in the closet where the litter that is tracked out on her paws can fall off before she exits.

The pet door was an easy installation. Picked up from a pet supply store, the pet door kit included a template for marking the location on the door. After drawing the template on the door, I drilled holes in the four corners to allow for my jigsaw blade. Then, it was just a matter of cutting around my drawn line with a jigsaw. Finally, the pet door frame snapped into place, which hid my somewhat sloppy cutting.

Of course, we don’t all have empty closet floors for our kitty’s boxes and some cats may not be willing to crawl through a pet door to get to theirs. Have you found any clever ways of hiding your cat’s litter box?

Add Comments